Gullsweep Home
Gullsweep Info
Order Gullsweep
Gullsweep Replacement Parts
GS Mounting Options
Gull sweep Other Uses
Gull sweep Instructions
Promo Items
Gull sweep Testimonials
Bird Study
Beaufort Scale
Gullsweep Mounting Options
Model GS-RK - GS-1 Retainer Kit (add it to your existing Gullsweep)
For those applications when a Gullsweep® could fall off of a non permanent mounting — i.e., GS-FM pulled from a canopy might turn sideways and the Gullsweep® could slide off the center mounting pin and go over board. Unfortunately, Gullsweeps® do not float.

Simple to install and will take the worry out of the situation.
Model GS-RK is made up of 4 pieces; SS Bracket, Shrink Tube, Grommet and O-ring.
  1. Slide shrink tubing over lower portion of center hub. Then, insert straight section of stainless steel bracket between hub and shrink tubing so bend is just above bottom of hub. Apply heat from a hair dryer while turning to shrink tubing tight to hub and bracket. Let cool. (A candle can also be used but do not over heat or let flame touch hub or shrink tube).
  2. Next, push Grommet over center support pin, Wide end first down to 3" from the tip (pointed end). Then slide o-ring to top of grommet to further secure.
  3. Slide Hub onto pin and gently pull SS bracket over grommet. Adjust grommet and o-ring position so there Is 1/8” or more clearance above and below grommet. Hub and SS bracket must not touch center pin or retaining ring.
Note: Remove Pin and Gullsweep® together by unscrewing wing nut & center pin.
No need to separate.

To order this retainer kit accessory (GS-RK) -$11.00 each Retainer Kit
For more information, call 201-670-0104 or email us at info@gullsweep.com.